Double Shower Curtain Rod Installation Instructions

The method may vary by manufacturer.

Double shower curtain rod installation instructions.

Drill pilot holes for the wall anchors. 6 with the fronts of the 2 covers facing together slide the covers onto the rod see figure c. Thread the shower curtain hooks rings through the curtain and liner. Then install the rod and place a level across the length of the rod.

Place the wall brackets onto the ends of the shower rod and tighten the set screws secure. There should be no gap between the base of the wall plate and the end of the rod. Before installing installation curved double shower curtain rod pencil level tape measure screwdriver drill hammer hacksaw drill bit 1. Install the first bracket by screwing it into place.

7 slide the 2nd wall plate into the rod as shown below see figure d. Straight double shower curtain rod installation 5. How to install spring loaded shower curtain rods. Extend the adjustable curved shower rod as needed until it is the correct length then install the other end of the rod into the bracket on the opposite wall.

If not trim with a hacksaw. For rods 84 and longer assemble with the connector piece. Verify that the rod sections are the proper length for your installation. Rotate the wall plate until it fits flush with the end of the rod.

Gently tap the anchors into the pilot holes with a hammer. Attach the rod and brackets to the wall with the mounting hardware provided. Once you find the proper height level the shower rod. Using the hardware that is incl.

X pilot hole anchor. In this video we walk you through the steps in which you need to take to install your kenney double curtain rod in your home. It may use spring loaded clips that fit into holes in the bracket or screws that secure the rod to the bracket. Install your brackets using these marks for a level rod.

Then move on to the next hole repeating the same process. Once level have an assistant mark where the rod intersects the other wall. Starting from the left side thread one ring through the holes of both the curtain and the liner. Hold it while you level the rod.

If there is a stud in your mounting location use wood screws to attach the wall brackets.